LABJACK RELAY DRIVER

Per the specifications in each devices datasheet, the DACs can generally source more current that digital outputs. Dry contact output is generally what you get from a mechanical relay. Optional Configuration to fix pull-up or turn off issues: For the LJTick-RelayDriver, the recommendation would be any relay that takes a control voltage of 50 volts or less at a current of mA or less. Mechanical Switch Closure 2. If for no other reason than to check the specs of the components. What can I try?

Uploader: Yokinos
Date Added: 9 May 2005
File Size: 46.67 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 6406
Price: Free* [*Free Regsitration Required]

Both of these are well above the 3. When the digital line is set to input, it is the equivalent of a 3. How do I write to internal flash? Please recommend if not.

They can source enough current to control almost any SSR and even labuack mechanical relays, and thus can be a convenient way to control 1 or 2 relays. What can I try?

The resulting voltage across the control inputs of the relay will be close to zero, as virtually all of the 1. Would be nice having a clear Would be nice having a clear recommendation what relay should labjzck connected and what not.

  G2 /QUADP-PL/7 DRIVER DOWNLOAD

They can control all SSRs and even many mechanical relays. When the digital line is set to output high, it is the equivalent of a 3. I’d like to see the full schematic for it, however. To continue this and discuss options, I would post on the forum and provide any more details you can gather about the control circuit for the MP Warranty, Liability, Compliance 1 – Installation 1. User menu Login Register Cart Contact. Normal Close is possible Lwbjack Whatever the load is, that is on the delay side, so it is isolated from the LabJack side, so the key point is just to keep it that way.

LJTick-RelayDriver | LabJack

Every LabJack is backed by our free Legendary Support, for life. Additionally, we provide all the software you need to get the most out of your LabJack.

Skip to main content. Once a month is the limit for these emails, but typical frequency is much less than that. Once a month is the limit for these emails, but typical frequency is much less than that.

The high side of each output switch. Click here to order! Might put the SSR control voltage in a region that is not defined by most labiack. I think we are going to need a lot more information to figure out what is going on.

  MSI PC11B2 DRIVER

I’d like to Useful add-on.

LJTick-RelayDriver Datasheet

If you have an AC load that is inductive motors, transformers. Unfortunately I have been running into dangerous territory. Please see the RB12 datasheet for more details.

Would be nice having a clear recommendation what relay should be connected and what not. The IO lines have ohms of series resistor that makes them unable to directly control most relays. If each switch has a different load voltage, the highest voltage should be connected to VR.

Of course the driver is wired to the digital IO ports. What version would be best? It gets more complicated to make something that can be high- or low-side. User menu Login Register Cart Contact.